help with strut |
Post Reply | Page <12 |
Author | |
8122pbrainard
Grand Poobah Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41040 |
Post Options
Thanks(0)
|
Greg, Can you see any cracking on the inside? The small cracks in the gel on the ouside around the strut pocket may be just some stress cracking but you may want to take a closer look at the large one in the middle. I would take a Dremel and with a small burr route it out and see how deep it goes below the gel. If it only goes into the first layer of glass, get some epoxy resin in as a first coat and then some epoxy filler over the top. If deeper, then a larger patch would be needed.
|
|
BuffaloBFN
Grand Poobah Joined: June-24-2007 Location: Gainesville,GA Status: Offline Points: 6094 |
Post Options
Thanks(0)
|
Hopefully you won't have to go this far, but you're in a similar starting place as I was. Mine was actually dripping so I knew I had troubles!
|
|
baumanmt
Senior Member Joined: March-05-2008 Location: United States Status: Offline Points: 105 |
Post Options
Thanks(0)
|
I cant tell on the inside because it is covered with a beige colored silicone or something. I'll clean all of this off and dremel out the crack and do some repair work.
Nice job with your repair Baffalo, it looks really nice-I hope I don't have to get that crazy with mine. |
|
gb842001
|
|
Post Reply | Page <12 |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |