G20 Reduced Flow Under Load |
Post Reply | Page <12 |
Author | |
KENO
Grand Poobah Joined: June-06-2004 Location: United States Status: Offline Points: 10688 |
Post Options
Thanks(0)
|
If I remember right you're an engineer at a power plant.
You must have something called "post maintenance testing" or some variation of those words after something is repaired. Just say that you're now a little smarter based on your experience |
|
Mille1sj
Senior Member Joined: October-01-2007 Location: United States Status: Offline Points: 276 |
Post Options
Thanks(0)
|
As always, I am happy that I checked here for info on rebuilding a G20. I am in the process of disassembling mine and have run into these same issues. I originally referenced the instructions on the Sherwood site, but they are not completely accurate. I was atempting to remove the pin in the pulley and decided to check her for info. I have been taking pictures every step to make sure I can get everything back together correctly.
|
|
tryathlete
Platinum Member Joined: April-19-2013 Location: Lake Villa, IL Status: Offline Points: 1797 |
Post Options
Thanks(0)
|
I’m glad that my water pump only weeps like a Bears fan. I’m going to wait until it weeps like a Packer’s fan before I rebuild it.
|
|
Mille1sj
Senior Member Joined: October-01-2007 Location: United States Status: Offline Points: 276 |
Post Options
Thanks(0)
|
Gary,
How did you remove the steel retaining housing? I am struggling to get mine out, do you reuse it? |
|
wiscofoot
Senior Member Joined: February-16-2018 Location: Neenah, Wi Status: Offline Points: 124 |
Post Options
Thanks(1)
|
I’m going to use the money I will save by not going to a packers playoff game to have the guy from Illinois on eBay rebuild my pump this winter.
|
|
1976 Martinique
|
|
Gary S
Grand Poobah Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
Post Options
Thanks(0)
|
I just gently used a small chisel and a punch to deform it and pull and pry it out, it is part of the seal assembly so a new one is included with the seal kit.
|
|
Mille1sj
Senior Member Joined: October-01-2007 Location: United States Status: Offline Points: 276 |
Post Options
Thanks(0)
|
Thanks, did you use the Sherwood Major Repair Kit 12665?
|
|
Gary S
Grand Poobah Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
Post Options
Thanks(0)
|
No I did 3 pumps at the same time and did not need everything so I bought what I needed separately looking for best price. 2 pumps are spares sitting on a shelf so I did not want impellers sitting in them . If you buy for example “Sherwood “ bearings they can be upwards of 28 dollars, I got the same NTN’s for around 13.
|
|
Post Reply | Page <12 |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |