What is it? |
Post Reply |
Author | |
AlfaDon
Senior Member Joined: September-18-2011 Location: San Leandro, Ca Status: Offline Points: 392 |
Post Options
Thanks(0)
Posted: May-12-2018 at 7:15pm |
Hey all
I pulled two of these off of my boat at some point and can’t remember where they go. I’m guessing that they help align the engine cover, but I don’t know. Thanks, and feel free to ridicule me about left over parts and the like (like you needed permission) Don |
|
AlfaDon
Senior Member Joined: September-18-2011 Location: San Leandro, Ca Status: Offline Points: 392 |
Post Options
Thanks(0)
|
|
|
gt40KS
Gold Member Joined: August-05-2017 Location: Wichita Kansas Status: Offline Points: 943 |
Post Options
Thanks(0)
|
Those were used on my Nautique at the bottom of the transom panels in front of the fuel tank - stops of sorts.
|
|
JCCI
1995 Ski Nautique GT40 |
|
AlfaDon
Senior Member Joined: September-18-2011 Location: San Leandro, Ca Status: Offline Points: 392 |
Post Options
Thanks(0)
|
Ok, that makes sense. To keep the transom panels from pushing into the fuel tank?
Thanks |
|
gun-driver
Grand Poobah Joined: July-18-2008 Location: Pittsburgh, Pa Status: Offline Points: 4112 |
Post Options
Thanks(0)
|
|
|
AlfaDon
Senior Member Joined: September-18-2011 Location: San Leandro, Ca Status: Offline Points: 392 |
Post Options
Thanks(0)
|
Thanks. They look like they're for holding the tank in place
|
|
gun-driver
Grand Poobah Joined: July-18-2008 Location: Pittsburgh, Pa Status: Offline Points: 4112 |
Post Options
Thanks(0)
|
Along with the strap's, I think they help to keep the tank from twisting maybe?? |
|
Jonny Quest
Grand Poobah Joined: August-20-2013 Location: Utah--via Texas Status: Offline Points: 2858 |
Post Options
Thanks(0)
|
As KS said, they are in front of the transom panels. They hold the panels in place in the event that you run with the rear bench seat removed.
JQ |
|
Current
2003 Ski Nautique 206 Limited Previous 2001 Ski Nautique Open Bow 1994 Ski Nautique Open Bow Aqua skiing, ergo sum |
|
gun-driver
Grand Poobah Joined: July-18-2008 Location: Pittsburgh, Pa Status: Offline Points: 4112 |
Post Options
Thanks(0)
|
My wedges are tight against the tank and the panels fit tight with the floor in front of them the wedges are not seen when the panels are in.
The panels wedge in tight with the floor and the upper holders/angle and don’t move around easily. Not sure it matters which way you use them. |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |