ebay or Craigs list? |
Post Reply ![]() |
Author | |
8122pbrainard ![]() Grand Poobah ![]() ![]() Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41040 |
![]() ![]() ![]() ![]() ![]() Posted: February-21-2009 at 11:51am |
I'm trying to find the post and link someone provided to the sale of a bunch of old deck hardware. I seem to remember it had flat glass windshield brackets that looked like the type Correct Craft used in the 40's and early 50's. I did a search and couldn't find it.
|
|
![]() |
|
Andy ![]() Senior Member ![]() ![]() Joined: July-27-2008 Location: M'boro, TN Status: Offline Points: 382 |
![]() ![]() ![]() ![]() ![]() |
Isnt it in someones resto thread? Who was goin to repop the step pads?
|
|
![]() |
|
Brady ![]() Senior Member ![]() Joined: June-28-2008 Location: Lake Elmo, Mn. Status: Offline Points: 226 |
![]() ![]() ![]() ![]() ![]() |
Pete
I'll bet Doc's looking for that post to! That post is vaguely familiar, but you know how that goes. |
|
Charlie
Three Lakes, Wisconsin 69 Barracuda |
|
![]() |
|
8122pbrainard ![]() Grand Poobah ![]() ![]() Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41040 |
![]() ![]() ![]() ![]() ![]() |
Chuck, Actually I'm looking for him! Right now he's having fun tinkering and familiarizing himself (again -it's bringing back memories!) with the engine. Lots of little things like where's the dip stick! The thought is that the engine hasn't been run since it was rebuilt and put back in the boat so there are some small issues - like the choke cable bracket was on the wrong carb! I did get some info on the engine and passed it on. The Gray 112 is a "Phantom" series which was there "hot" engine before the Fireballs. High compression and lighter flywheel got it up 115Hp at a red line of 3600!!!! (the standard would be 3200) Premium gas is needed - the manual even refers to it as "Ethel"! BTW, JD thinks he has the brochure on the Dart! |
|
![]() |
|
LaurelLakeSkier ![]() Senior Member ![]() ![]() Joined: February-12-2007 Location: Wisconsin Status: Offline Points: 485 |
![]() ![]() ![]() ![]() ![]() |
Has Billy had the boat in the water and running or is he working on it on the trailer?
|
|
![]() |
|
boat dr ![]() Grand Poobah ![]() ![]() Joined: June-27-2004 Location: United States Status: Offline Points: 4245 |
![]() ![]() ![]() ![]() ![]() |
No he has not had it near the water yet... Still trying to figure this antique out. Lottsa stuff in here that don't look right.
The motor is in "BACKARKS", there are only three fill caps on the battery and they purposely hid the oil dipstick to further confuse me. Lot to learn about "OLD SCHOOL" marine design from the 1940's. I am just amazed at how little I know, but this will change. Kinda feel like Gregg the first time he opened up his big block, now after several hours of R&R he has a well deserved Tee Shirt. It reads "BEEN THERE / DONE THAT" Hope to earn mine soon........ Just got the old girl firing and will soon see if she will do more than spin and spark.What a "HOOT" ........Boat dr |
|
![]() |
|
Brady ![]() Senior Member ![]() Joined: June-28-2008 Location: Lake Elmo, Mn. Status: Offline Points: 226 |
![]() ![]() ![]() ![]() ![]() |
Pete,
How did you get to JD, Carrier Pigeon? Can you Email me his phone # as I'm going back to 3 LKS tomorrow. Doc that looks to be a fun project! Good luck with it. Mark when are going up next? |
|
Charlie
Three Lakes, Wisconsin 69 Barracuda |
|
![]() |
|
The Lake ![]() Platinum Member ![]() ![]() Joined: May-13-2005 Location: Lk Winnebago MO Status: Offline Points: 1157 |
![]() ![]() ![]() ![]() ![]() |
Life's a journey for sure Boat Dr. I got a hunch you'll have that boat running better than it was in 1949. Chuck |
|
![]() |
|
Riley ![]() Grand Poobah ![]() ![]() Joined: January-19-2004 Location: Portland, ME Status: Offline Points: 7952 |
![]() ![]() ![]() ![]() ![]() |
I like the upside down carbs, and the raw water pump looks like it driven off of the generator. Is it 6 volt?
|
|
![]() |
|
8122pbrainard ![]() Grand Poobah ![]() ![]() Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41040 |
![]() ![]() ![]() ![]() ![]() |
![]() |
|
![]() |
|
Munday ![]() Gold Member ![]() Joined: August-17-2004 Location: United States Status: Offline Points: 538 |
![]() ![]() ![]() ![]() ![]() |
There was a guy on e bay that had several sets of new old stock side brackets but no centers.I'll see if I saved anything from that he wasn't having any luck on ebay and had about 20 sets nos
Bob |
|
If the only tool you have is a hammer,everything starts to look like a nail.
|
|
![]() |
|
8122pbrainard ![]() Grand Poobah ![]() ![]() Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41040 |
![]() ![]() ![]() ![]() ![]() |
Billy,
Get in touch with Bob (munday) Be carefull with the available reproductions as they are made for the Chris Crafts, etc. Correct Craft used brackets that I've rarely seen on other boats. We need to look at pictures very carfully. As long as you're doing it, there's no sence in getting brackets that aren't appropriate. |
|
![]() |
|
8122pbrainard ![]() Grand Poobah ![]() ![]() Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41040 |
![]() ![]() ![]() ![]() ![]() |
diary pictures
more again You'll notice that the side brackets sweep aft quite alot and have the rather long gusset. |
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |