Print Page | Close Window

Bilge blower location 83 ski Nautique 2001

Printed From: CorrectCraftFan.com
Category: General Correct Craft Discussion
Forum Name: General Discussion
Forum Discription: Anything Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=50064
Printed Date: April-28-2024 at 1:16pm


Topic: Bilge blower location 83 ski Nautique 2001
Posted By: Wichitabub
Subject: Bilge blower location 83 ski Nautique 2001
Date Posted: July-26-2021 at 11:53am
I need the location of the bilge blower, I’m sure it needs to be replaced,because when the switch is turned on,nothing happens. Thanks Bob in Wichita


Replies:
Posted By: 8122pbrainard
Date Posted: July-26-2021 at 12:13pm
Bob,
Before you condemn the blower, get the VOM (volt Ohm Meter) out and do some checking. Start at the switch to see if you are getting the volts out of it. Maybe it's just the switch? You should have the combination breaker/switches and they are known to go bad.  


-------------
/diaries/details.asp?ID=1622" rel="nofollow -

54 Atom

/diaries/details.asp?ID=2179" rel="nofollow - 77 Tique

64 X55 Dunphy

Keep it original, Pete
<

Posted By: MourningWood
Date Posted: July-26-2021 at 3:40pm
The blower can be found above the fuel tank

-------------
1994 Ski Nautique "Riot"
1964 Dunphy X-55 "One 'N Dun"

'I measured twice, cut three times, and it's still too short!"

Posted By: Wichitabub
Date Posted: July-27-2021 at 12:44pm
Thanks for the information,it’s appreciated

Posted By: GeoB
Date Posted: August-02-2021 at 9:24pm
Thanx for this post.

I just purchased my first boat, 1985 SN 2001.

Dead blower motor.

Turned out it is that switch/breaker.

I ordered one and it has slide on connections. I’m thinking that I want the screw connections as I have to avoid vibration issues.

Any suggestions to source them?

-------------
Geo


Print Page | Close Window