Print Page | Close Window

wiring diagram for 2007 SAN

Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Engine Repair
Forum Discription: Engine problems and solutions
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=34907
Printed Date: April-29-2024 at 4:09am


Topic: wiring diagram for 2007 SAN
Posted By: aebert2668
Subject: wiring diagram for 2007 SAN
Date Posted: November-12-2014 at 11:06am
Does anyone have access to a wiring diagram for a SAN 2007? Specifically the fuel pump wiring.



Replies:
Posted By: Nautiquehunter
Date Posted: November-13-2014 at 11:31am
It is actually a 2006 220 5.7 L It cranks but no start,there is no spark and no power to the fuel pump I do have power to the Ign coil.
I have 1 hot and 2 grounds at the fuel pump relay the forth wire is the control power to energize the relay. it is supposed to be hot for 2.5 sec when the key is turned on and then is powered by the ECM when it sees RPM pulses . In automotive applications the circuit goes through the oil sender and will only supply power when the oil pressure is OK. I would love to have a complete wiring diagram from the keypad to the relays on the engine? At this point I suspect the ECM but I don't want to guess on an expensive part.


Posted By: quinner
Date Posted: November-13-2014 at 12:46pm
Mike, when you find the diagram it would be great if you could post it here or email to Keith to add to the reference section.

Is 06' the first year of TBW?? If not and the ECM proves to be bad, here is a possible option:
http://www.ski-it-again.com/php/skiitagain.php?endless=summer&topic=Search&category=Parts_Engine&postid=28237" rel="nofollow - http://www.ski-it-again.com/php/skiitagain.php?endless=summer&topic=Search&category=Parts_Engine&postid=28237


Posted By: Nautiquehunter
Date Posted: November-13-2014 at 2:37pm
Thanks Chris I sent a message to PCM and Nautique Parts . I wonder if there is a shop manual available . I had no idea there was so little information out for late model boats?


Posted By: quinner
Date Posted: November-13-2014 at 3:00pm
Mike, I may have something you can use.

EMail me at CQuinn at GFGR dot com since I can't figure out how to upload a PDF

Can anyone guide me on uploading a PDF here??


Posted By: Bri892001
Date Posted: November-14-2014 at 3:56pm
Hi Quinner,

Sometimes a PDF can be saved as an image (jpg etc.)

If one of you guys PMs me, I'll send over my email address. I should be able to convert the PDF to an image.


Posted By: quinner
Date Posted: November-14-2014 at 4:59pm
Thanks Brian, sent Keith a copy for the reference section.

I could convert to JPG or whatever but I believe each page will become an individual file and this manual is like 350 pages, yikes.



Print Page | Close Window