Forums
NautiqueParts.comNautiqueSkins.com - Correct Craft Upholstery and Part
  New Posts New Posts RSS Feed - Bilge pump
  FAQ FAQ  Forum Search   Register Register  Login Login

Bilge pump

 Post Reply Post Reply   
Author
Kat Daddy View Drop Down
Newbie
Newbie
Avatar

Joined: June-19-2018
Location: Columbiana, Al
Status: Offline
Points: 35
Post Options Post Options   Thanks (0) Thanks(0)   Quote Kat Daddy Quote  Post ReplyReply Direct Link To This Post Topic: Bilge pump
    Posted: April-10-2021 at 1:17pm
My bilge pump has stopped working due to a possible short in a wire. Pump does work when wired straight to the battery. When the bilge switch is turned on, the ignition light dims and then the circuit breakers pops. Is there a known wiring diagram so i can trace wiring and see what may be wrong? Has anyone else had this issue?
Back to Top
8122pbrainard View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: September-14-2006
Location: Three Lakes Wi.
Status: Offline
Points: 41040
Post Options Post Options   Thanks (0) Thanks(0)   Quote 8122pbrainard Quote  Post ReplyReply Direct Link To This Post Posted: April-10-2021 at 1:27pm
Trey,
I have a feeling you may need a new pump. It's drawing the amps over what it should and triping the breaker. It runs when connected directly to the battery because there isn't a breaker to trip. The only other problem may be a bad breaker but I suspect the pump to be the problem. You could check amp draw with a VOM ( volt Ohm mete) with a 20 amp setting. 


54 Atom


77 Tique

64 X55 Dunphy

Keep it original, Pete
<
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Copyright 2024 | Bagley Productions, LLC