Boats For Sale:
morris hydrolic steering |
Post Reply 
|
| Author | |
doug e 
Newbie 
Joined: October-24-2006 Location: United States Status: Offline Points: 25 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: morris hydrolic steeringPosted: March-12-2007 at 9:54am |
|
I have an morris hydrolic helm with a bad seal, does anyone know where to get parts for one?? Thanks
|
|
|
Cheap thrill fishing team
|
|
 |
|
|
boat dr
Grand Poobah 
Joined: June-27-2004 Location: United States Status: Offline Points: 4245 |
Post Options
Thanks(0)
Quote Reply
Posted: March-12-2007 at 10:27am |
|
Doug, is the helm leaking or is it the cyl.
I don't see any parts nor listing for the Morse hyd. steering,Sea star,made by Teleflex /Morse,also Baystar,same Co. You may have to replace the unit.......boat dr |
|
|
|
|
8122pbrainard
Grand Poobah
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41040 |
Post Options
Thanks(0)
Quote Reply
Posted: March-12-2007 at 11:23am |
|
Doug, If it's just a bad seal, then it may be located through a industrial power transmission supply. If it's a shaft or cylinder, it's probably a standard off the shelf seal and should have a # printed on it. However, a bad seal may be caused by internal wear so go by what the boat dr. says and look into it farther.
|
|
|
|
|
doug e
Newbie
Joined: October-24-2006 Location: United States Status: Offline Points: 25 |
Post Options
Thanks(0)
Quote Reply
Posted: March-12-2007 at 12:56pm |
|
It's the helm seal (the one that pops out), I took the seal to the local marine dist. and nothing he had matched up.
|
|
|
Cheap thrill fishing team
|
|
|
|
|
8122pbrainard
Grand Poobah
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41040 |
Post Options
Thanks(0)
Quote Reply
Posted: March-12-2007 at 1:25pm |
|
Doug, Look in your yellow pages under power tranmission to see whats close to you. This is not the transmision in you car catagory!! It's sprockets,gears,bearings,motors,drive belts,etc. and of coarse seals. Keep in mind that there may be internal wear in the helm that caused the seal to fail. Good luck.
|
|
|
|
|
doug e
Newbie
Joined: October-24-2006 Location: United States Status: Offline Points: 25 |
Post Options
Thanks(0)
Quote Reply
Posted: March-23-2007 at 11:30am |
|
Thanks for the help, a local trans. shop found me a good replacement for it!!!
|
|
|
Cheap thrill fishing team
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options