Boats For Sale:
remounting bilge pump switch plate |
Post Reply 
|
| Author | |
uncle-buck 
Senior Member 
Joined: June-14-2004 Location: United States Status: Offline Points: 318 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: remounting bilge pump switch platePosted: September-22-2022 at 2:05pm |
|
I want to mount a new automatic bilge pump switch in the bilge of my boat..
One of the screws whose purpose is to secure the mounting plate in the bilge works. The other one doesn't and its insert or nut has vanished. What are some ways to install a new nut or insert in the bilge? And what material is recommended as a sealant for the underside of the mounting plate? Should all of the old material be scraped off? Thanks  |
|
|
1990 Ski Nautique (original owner)
PCM 351W with D.U.I. |
|
 |
|
|
Mpost
Senior Member
Joined: July-05-2018 Location: Monticello, MN Status: Offline Points: 329 |
Post Options
Thanks(1)
Quote Reply
Posted: September-23-2022 at 8:47am |
|
I would clean up the area good and fill the hole and level the area with PL400 or equivalant. Then drill new pilot hole (shallow) for the screw.
Or replace your pump with a new one that has the automatic float already in it. ????
|
|
|
84 SN Sold 98 SN Lund Pro V 1975 Alumacraft
|
|
|
|
|
uncle-buck
Senior Member
Joined: June-14-2004 Location: United States Status: Offline Points: 318 |
Post Options
Thanks(0)
Quote Reply
Posted: September-30-2022 at 7:39am |
|
Have already purchased a NOS Water Witch and plan to install it using your recommendations. Thank you.
|
|
|
1990 Ski Nautique (original owner)
PCM 351W with D.U.I. |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options