Forums
NautiqueParts.comNautiqueSkins.com - Correct Craft Upholstery and Part
  New Posts New Posts RSS Feed - 1964 Dunphy (or other) stern light base
  FAQ FAQ  Forum Search   Register Register  Login Login

1964 Dunphy (or other) stern light base

 Post Reply Post Reply   
Author
MourningWood View Drop Down
Gold Member
Gold Member


Joined: June-13-2014
Location: NorCal
Status: Offline
Points: 885
Post Options Post Options   Thanks (0) Thanks(0)   Quote MourningWood Quote  Post ReplyReply Direct Link To This Post Topic: 1964 Dunphy (or other) stern light base
    Posted: March-08-2022 at 7:13pm
Trying to find a stern light pole for '64 Dunphy. Base has 3 mount screws, 2-pin light base, knurled tighten knob. Only markings on bottom are "CA 6224-04". Tried a Perko mast-too loose, and pins don't line up. Any ideas?
(will try and post photo)


1994 Ski Nautique "Riot"
1964 Dunphy X-55 "One 'N Dun"

'I measured twice, cut three times, and it's still too short!"
Back to Top
Riley View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: January-19-2004
Location: Portland, ME
Status: Offline
Points: 7946
Post Options Post Options   Thanks (0) Thanks(0)   Quote Riley Quote  Post ReplyReply Direct Link To This Post Posted: March-09-2022 at 6:56am
That looks like a "Jetson Stern Light" base.  Keep an eye on ebay.  They come up.  Most that I have seen did not have the removable pole, but the pole receded into the deck.  I've seen some for sale with the removable pole that had a square base.  If you have room below deck for the pole to recede, you may be able to convert yours if you cannot find the type you have. 

Back to Top
swilliams View Drop Down
Senior Member
Senior Member
Avatar

Joined: June-26-2016
Location: Cincinnati,Ohio
Status: Offline
Points: 234
Post Options Post Options   Thanks (0) Thanks(0)   Quote swilliams Quote  Post ReplyReply Direct Link To This Post Posted: March-09-2022 at 9:32am
Definitely an Attwood base. Pretty sure you’ll find one but they may be expensive. I’ll keep an eye out.
1976 Martinique,350 Omc. 1975 Glastron/Carlson CV16,115 Merc.
Back to Top
MourningWood View Drop Down
Gold Member
Gold Member


Joined: June-13-2014
Location: NorCal
Status: Offline
Points: 885
Post Options Post Options   Thanks (0) Thanks(0)   Quote MourningWood Quote  Post ReplyReply Direct Link To This Post Posted: March-09-2022 at 10:27am
Fellas, thank you so much. Riley, that looks exactly like my photo.  I do have the base (in photo)...but never had the lamp portion. I don't think it 'retracts', as the fuel tank is just below deck. 
I'll check e-pay and elsewhere...and thanks again!
1994 Ski Nautique "Riot"
1964 Dunphy X-55 "One 'N Dun"

'I measured twice, cut three times, and it's still too short!"
Back to Top
h2oproofer View Drop Down
Newbie
Newbie


Joined: May-17-2010
Location: Alabama
Status: Offline
Points: 4
Post Options Post Options   Thanks (0) Thanks(0)   Quote h2oproofer Quote  Post ReplyReply Direct Link To This Post Posted: July-17-2022 at 10:53am
Did y ever finish dunphy emblem project?   I am in need of a set
Back to Top
MourningWood View Drop Down
Gold Member
Gold Member


Joined: June-13-2014
Location: NorCal
Status: Offline
Points: 885
Post Options Post Options   Thanks (0) Thanks(0)   Quote MourningWood Quote  Post ReplyReply Direct Link To This Post Posted: July-17-2022 at 11:12am
I'm happy to report...yes. The emblems have been signed off (by me) and are at chroming. The Dunphy scripts and both sides of the "flag" logo. (They each wave astern). They will come with adhesive-backing since we didn't want to drill holes (that may or may not line up). Hole can be drilled if preferred. Should be ready in about 3 weeks. 
Also, I did find a correct rear stern light pole. 
Thanks
Tell us about your X...
1994 Ski Nautique "Riot"
1964 Dunphy X-55 "One 'N Dun"

'I measured twice, cut three times, and it's still too short!"
Back to Top
MourningWood View Drop Down
Gold Member
Gold Member


Joined: June-13-2014
Location: NorCal
Status: Offline
Points: 885
Post Options Post Options   Thanks (0) Thanks(0)   Quote MourningWood Quote  Post ReplyReply Direct Link To This Post Posted: July-17-2022 at 11:13am
and, where has Pete been hiding?...
1994 Ski Nautique "Riot"
1964 Dunphy X-55 "One 'N Dun"

'I measured twice, cut three times, and it's still too short!"
Back to Top
h2oproofer View Drop Down
Newbie
Newbie


Joined: May-17-2010
Location: Alabama
Status: Offline
Points: 4
Post Options Post Options   Thanks (0) Thanks(0)   Quote h2oproofer Quote  Post ReplyReply Direct Link To This Post Posted: August-01-2022 at 10:43pm
I have a 63 and 64 dated dunphy
I know they say 64 was first year but serial is 63-
The 63 has new wood bottom, rebuilt 312 original, new upholstery w proper stitching in lines.   Multi year restoration a little here and there

About ready to start the second boat but will be short a set of emblems
Reason I was curious about yours. Would love to see when done and be interested in how to get a set made as well.   
Back to Top
MourningWood View Drop Down
Gold Member
Gold Member


Joined: June-13-2014
Location: NorCal
Status: Offline
Points: 885
Post Options Post Options   Thanks (0) Thanks(0)   Quote MourningWood Quote  Post ReplyReply Direct Link To This Post Posted: August-01-2022 at 11:48pm
h20proofer-sent you a pm
1994 Ski Nautique "Riot"
1964 Dunphy X-55 "One 'N Dun"

'I measured twice, cut three times, and it's still too short!"
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Copyright 2024 | Bagley Productions, LLC