1969 Passenger Windshield Needed |
Post Reply |
Author | |
Trent
Newbie Joined: March-21-2005 Location: United States Status: Offline Points: 23 |
Post Options
Thanks(0)
Posted: March-21-2005 at 6:26pm |
My little brother dropped a scaffold on the passenger (left) half of the windshield on my 1969 Mustang. I would like to purchase the half including the aluminum edge and angle piece that attaches to the gunwale. I guess I could replace the entire thing, but I'd prefer to replace the half. I'm looking for a low cost solution. Any ideas would be appreciated.
I also just replaced the old ford 289 with a Chrysler 318. I replaced the engine because new exhaust manifolds were more expensive than a the slightly used 318 my buddy had. The ford engine has an working transmission, new distributor, a starter that was rebuilt last summer, a good alternater, a nice holley four barrel, new rods, and some other goodies. I would very much like to trade ford engine parts for a windshield that will work in my application. -Trent |
|
ctrentbp@yahoo.com
|
|
jsunny
Newbie Joined: September-14-2005 Status: Offline Points: 1 |
Post Options
Thanks(0)
|
I might be interested in some of the parts off of your 289 Ford. I have a 69 Mustang the has a 302 in it. Manifolds are going too, replaced one looking for another. Do you have any other parts worth taking/selling.
Jeff |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |