manifold risers |
Post Reply |
Author | |
trikeaholic
Senior Member Joined: August-10-2005 Location: United States Status: Offline Points: 163 |
Post Options
Thanks(0)
Posted: August-12-2005 at 11:43pm |
need a set of the low profile exhaust manifold risers for my 80 SN. Former owner replaced with some hi-rise ones and had to raise the dog house with a strange wooden contraption. Want it gone. Exterior rust is ok, would like really nice internals. Would trade for the hi-risers on my boat, they are in good condition.
mt91397@yahoo.com located Ithaca, NY |
|
WOODYELC
Guest |
Post Options
Thanks(0)
|
THE LAST OWNER PROBLEY USED OSCO OR BARR MANIFOLDS WHICH ARE ABOUT 1 TO 2 INCHS WIDER THAN THE P.C.M. SYSTEM. THAT IS REASON FOR THE PLATFORM UNDER THE BOX SO IT WILL CLOSE.
|
|
trikeaholic
Senior Member Joined: August-10-2005 Location: United States Status: Offline Points: 163 |
Post Options
Thanks(0)
|
correct they are barr. So I need manifolds too?? OUCH!
If I buy new, think I could dump the Barrs off easily on ebay? for at least half of what I payfor new PCM stuff? Man that stinks. |
|
WOODYELC
Guest |
Post Options
Thanks(0)
|
YOU SHOULD BE ABLE TO SELL THEM WITH NO PROBLEM. A COMPLETE SET OF P.C.M. MANIFOLDS AND RISERS WITH HARDWARE IS 750.00 PLUS SHIPPING.
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |