Building ’90 SN rear bench
Printed From: CorrectCraftFan.com
Category: General Correct Craft Discussion
Forum Name: General Discussion
Forum Discription: Anything Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=2781
Printed Date: May-14-2024 at 10:51pm
Topic: Building ’90 SN rear bench
Posted By: kernal
Subject: Building ’90 SN rear bench
Date Posted: December-07-2005 at 5:46am
I am building a rear bench seat and have no reference to go off of. I was wondering if anyone had pictures of the bench out of the boat. As well as pictures of the back of the rear bench. I heard there is a metal bracket that picks of the back of the seat, yet I have not seen pictures of how it adheres to the bench.
Thank You
|
Replies:
Posted By: 82tique
Date Posted: December-07-2005 at 7:49am
|
What year and model boat?
|
Posted By: David F
Date Posted: December-07-2005 at 9:33am
|
Sorry, I do not have pictures. But, I think the bracket you are asking about is simply a metal tab in slot setup. there is one in the center of the back and one on each side or wing. the purpose is mainly to "hang" the seat back in place as it does not rest on the floor of the boat.
|
Posted By: TRBenj
Date Posted: December-07-2005 at 9:35am
I believe he's looking for the back seat from a '90 Ski Nautique (as the t*tle states).
I dont have a pic of mine, so here a description: The back of the seat is solid plastic and pretty much sits flush against the edge of the top deck. The metal bracket on the seat simply slides over the bracket mounted on the boat- pretty simple.
Dont know if that helps you or not- sorry!
-------------
|
Posted By: 82tique
Date Posted: December-07-2005 at 9:53am
Sorry....missed the year info in the t*tle.
|
|