Checking trans fluid |
Post Reply |
Author | |
ETALLEN
Groupie Joined: July-25-2017 Location: Greenback tn Status: Offline Points: 83 |
Post Options
Thanks(0)
Posted: June-23-2019 at 2:04am |
Just completed my first fluid change one the new to me 176. Impeller is on the board for tomorrow.
The one question I have is the trans fluid dipstick. It's milled on one side and has two lines cut into it, I'm assuming below the first line is low between the two is ideal operating range? Do I push the dipstick in all the way when checking? Manual does not provide real clear into Thanks |
|
the final price is always cheaper when the beer is free
|
|
KENO
Grand Poobah Joined: June-06-2004 Location: United States Status: Offline Points: 10643 |
Post Options
Thanks(0)
|
old post about 1.23 to 1 transmission fluid check
link Never has something with no moving parts been so hard to use. And it's not your fault |
|
KENO
Grand Poobah Joined: June-06-2004 Location: United States Status: Offline Points: 10643 |
Post Options
Thanks(0)
|
I'd just do the cold check referenced in the link in the previous post after things have sat overnight for a consistent way of checking level.
Or in other words do it the same way under the same conditions every time for consistency |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |