Site Sponsors:
Brochures:
1987 Correct Craft Manufacturer's Marketing Report
1987 Correct Craft Brochure
1988 Correct Craft Brochure
1988 Correct Craft 'Short' Brochure
1989 Correct Craft Brochure
Brochures:1987 Correct Craft Manufacturer's Marketing Report
1987 Correct Craft Brochure
1988 Correct Craft Brochure
1988 Correct Craft 'Short' Brochure
1989 Correct Craft Brochure
Diaries | Details
This boat's story has been posted by the owner. Please contact the owner with any questions. You may use the form below to send the owner an email.
Updated:
6/24/2018 (6 years ago)
Originally Posted: 2/14/2018
Total Views: 2,185
Owner: David G
Forum Nickname: dgabler
Location: Atascadero, CA
Model: 1988 Ski Nautique
Length: 0
Engine:
HP: 0
Hours: 445
Modify this Diaries Listing
Forum Nickname: dgabler
Location: Atascadero, CA
Model: 1988 Ski Nautique
Length: 0
Engine:
HP: 0
Hours: 445
Modify this Diaries Listing
Our 88 Our 88 SN2001
'17 season work
+ Replaced
- Ignition key
- coil (to solve issue where hot re-starts were not possible)
- raw water impeller
+ Added
- battery tender
'17 Layup work done
+Replaced
- leaking drive shaft gland
- raw water impeller
- water & alt belts
- engine / driveshaft alignment
- upgraded prop to ACME 540 (13x12R) from Federal 13RH13
- glassed over small dent in starboard impeller
- relocated cupholder to header vent
- relocated heater vent to drivers feet
+Added
- satellite radio receiver
- bluetooth speaker
- multi style charge point to glovebox for USB (Mini,Micro,C,Lightning ports)
- 12v port below rear facing seat for tube inflation
Current Proposed '18 layup
- Cutlass bearing replacement
- New A.R.E. DT shaft
- New stuffing box & Log shaft <-> box tube
- New sparkplugs
- New sparkplug wires
'17 season work
+ Replaced
- Ignition key
- coil (to solve issue where hot re-starts were not possible)
- raw water impeller
+ Added
- battery tender
'17 Layup work done
+Replaced
- leaking drive shaft gland
- raw water impeller
- water & alt belts
- engine / driveshaft alignment
- upgraded prop to ACME 540 (13x12R) from Federal 13RH13
- glassed over small dent in starboard impeller
- relocated cupholder to header vent
- relocated heater vent to drivers feet
+Added
- satellite radio receiver
- bluetooth speaker
- multi style charge point to glovebox for USB (Mini,Micro,C,Lightning ports)
- 12v port below rear facing seat for tube inflation
Current Proposed '18 layup
- Cutlass bearing replacement
- New A.R.E. DT shaft
- New stuffing box & Log shaft <-> box tube
- New sparkplugs
- New sparkplug wires