Forums
NautiqueParts.comNautiqueSkins.com - Correct Craft Upholstery and Part
  New Posts New Posts RSS Feed - Help overheating
  FAQ FAQ  Forum Search   Register Register  Login Login

Help overheating

 Post Reply Post Reply   
Author
eric lavine View Drop Down
Grand Poobah
Grand Poobah


Joined: August-13-2006
Location: United States
Status: Offline
Points: 13413
Post Options Post Options   Thanks (0) Thanks(0)   Quote eric lavine Quote  Post ReplyReply Direct Link To This Post Topic: Help overheating
    Posted: April-12-2008 at 11:21am
put running water near the rwp,at the shaft, if its pulling air this trick will clear it momentarily, you may have to do this for a few minutes for the temperature to regulate, the shaft seals are commonly overlooked and if pulling air will turn the water into airiated water which does not transfer heat
"the things you own will start to own you"
Back to Top
BuffaloBFN View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: June-24-2007
Location: Gainesville,GA
Status: Offline
Points: 6094
Post Options Post Options   Thanks (0) Thanks(0)   Quote BuffaloBFN Quote  Post ReplyReply Direct Link To This Post Posted: April-10-2008 at 11:04pm
Welcome aboard Rob! I answered on your other post...
1988 BFN-sold



"It's a Livin' Thing...What a Terrible Thing to Lose" ELO
Back to Top
Policerob View Drop Down
Newbie
Newbie


Joined: April-10-2008
Status: Offline
Points: 8
Post Options Post Options   Thanks (0) Thanks(0)   Quote Policerob Quote  Post ReplyReply Direct Link To This Post Posted: April-10-2008 at 9:30pm
I have an 83 correct craft ski nautique. On the hose at home eng runs fine... Normal temp, (I hypothesized this is from my house water presser pushing water through-ought the system)... put it on the lake and temp shoots up over 230. I have a t.stat that is 160 for PCM. I have tested the water pump and replaced the impeller, tested each connection for possible air leeks with neg/ results. Systematically using a 5 gallon bucket and timed the time it takes to drain the bucket approximately 20 sec @ 2500 RPM. The only thing I can think of is that my skimmer top is linking air into the system if there is any one with a PCM Ford setup like my 83, can you look and see if the skimmer has an O-ring for the top and is so any ideas if this is my problem since I have excluded the water pump as being my problem.. Thanks Rob
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Copyright 2024 | Bagley Productions, LLC